Are you talking about scanning for digitizing or scanning for RP?
A few years back I remember hearing about a STEP initiative to define a
neutral digitizer data format. I'm not sure
this got very far.
bert
----------------------
Chris Sutcliffe wrote:
> Dear List I may be showing my ignorance here but is there an industry
> standard method for the representation of scan vector information. We
> are currently writing some software which takes and slices STLs and
> then outputs different scan strategies. It would be nice to write the
> output in an industry standard format if there is one. Any comments
> would be appreciated Thanks in advance Chris Dr. Chris. Sutcliffe
> Rapid Prototyping and Micromanufacture Research
> Department of Engineering
> 3 Brownlow St.
> Liverpool L69 3GL (0151) 794 8022 Direct
> (0151) 794 7729 Mobile
> (0151) 794 8021 Secretary EMail c.j.sutcliffe@liv.ac.uk
-- Bert van den Berg bert@hymarc.com Applications Engineer ftp://ftp.hymarc.com Hymarc Ltd. http://www.hymarc.com 35 Antares Drive Tel: (613) 727-1584 Ottawa, Canada, K2E 8B1 Fax: (613) 727-0441For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:31 EEST