Dear Bert and List
I was talking about scanning for RP not for digitisation sorry for any
confusion
Thanks
Chris
----- Original Message -----
From: Bert van den Berg <bert@hymarc.com>
To: Chris Sutcliffe <c.j.sutcliffe@liverpool.ac.uk>
Cc: rpml <rp-ml@bart.lpt.fi>
Sent: 18 May 2000 15:06
Subject: Re: Scan formats
> Are you talking about scanning for digitizing or scanning for RP?
>
> A few years back I remember hearing about a STEP initiative to define a
> neutral digitizer data format. I'm not sure
> this got very far.
>
> bert
> ----------------------
> Chris Sutcliffe wrote:
>
> > Dear List I may be showing my ignorance here but is there an industry
> > standard method for the representation of scan vector information. We
> > are currently writing some software which takes and slices STLs and
> > then outputs different scan strategies. It would be nice to write the
> > output in an industry standard format if there is one. Any comments
> > would be appreciated Thanks in advance Chris Dr. Chris. Sutcliffe
> > Rapid Prototyping and Micromanufacture Research
> > Department of Engineering
> > 3 Brownlow St.
> > Liverpool L69 3GL (0151) 794 8022 Direct
> > (0151) 794 7729 Mobile
> > (0151) 794 8021 Secretary EMail c.j.sutcliffe@liv.ac.uk
>
> --
> Bert van den Berg bert@hymarc.com
> Applications Engineer ftp://ftp.hymarc.com
> Hymarc Ltd. http://www.hymarc.com
> 35 Antares Drive Tel: (613) 727-1584
> Ottawa, Canada, K2E 8B1 Fax: (613) 727-0441
>
>
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:32 EEST