Re: [rp-ml] Low Cost RP and easy to use RP Equipment?

 
In a message dated 1/1/2011 5:13:45 A.M. Eastern Standard Time,
chuck@churtle.com writes:

Hi everyone,

Happy New Year!

I'm looking for a low cost and easy to use RP machine for my personal use
and very limited commercial use. Not looking to spend a lot of time with
cleaning parts and want as close to "plug and play" as possible.

Looking at the VFlash and the uPrint, but can anyone offer some other
suggestions? I know some cool stuff must have come out of Euromold.

Not So Rigid Requirements:

* $15k Budget
* Don't care about colors
* Easy postprocessing
* Cheap Material
* Good accuracy (100 microns)
* Small build area is ok
* Slow build time is ok

Objet Alaris is out of my budget range, but seemed like a great choice.

Thanks for the help!

-Chuck Stapleton

Chuck:
 
Every available choice on earth selling for less than US$20,000 is listed
on this page - and don't miss the accompanying comparative table of
specifications.
 
Anything not listed is simply one of these sold under another name:
 
_http://www.additive3d.com/comp_lks.htm_
(http://www.additive3d.com/comp_lks.htm)
 
 
Happy and healthy 2011 to all!
 
 
Ed

Ed Grenda
Castle Island Co.
_EdGrenda@aol.com_ (mailto:EdGrenda@aol.com) (email)

The Worldwide Guide to Rapid Prototyping
www.additive3d.com
Received on Sat Jan 01 21:13:24 2011