Converting DXF to STL

From: Mitchell J. A (mitchelj@msoe.edu)
Date: Wed Apr 28 1999 - 01:39:11 EEST

Next message: Paul Burr: "Re: Low cost RP..."
Previous message: Lightman, Allan J: "SOTI Report at SME"
Next in thread: Delft Spline Systems: "Re: Converting DXF to STL"
Maybe reply: Delft Spline Systems: "Re: Converting DXF to STL"
Maybe reply: Tom Vorgitch: "Re: Converting DXF to STL"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello RPML Subscribers,

Does anyone know how to convert a *.dxf file to a *.stl file?? It is a
scanned image of persons' face, but the *.dxf file is full of open
triangles.

If anyone can help I will greatly appreciate it.

Thank you in advance,

J. Mitchell
SLS Operator
MSOE-RPC
(414)-277-7189

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Paul Burr: "Re: Low cost RP..."
Previous message: Lightman, Allan J: "SOTI Report at SME"
Next in thread: Delft Spline Systems: "Re: Converting DXF to STL"
Maybe reply: Delft Spline Systems: "Re: Converting DXF to STL"
Maybe reply: Tom Vorgitch: "Re: Converting DXF to STL"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:34 EEST