TPE Question

From: Brad W. Wright, Ph.D., P.E. (WrightEngr@gomontana.com)
Date: Tue Aug 25 1998 - 23:20:58 EEST

Next message: Deak, Steve: "SLA500 Solid State Upgrade"
Previous message: liu@ncatmail.ncat.edu: "SME Region 2 Career Fair"
Next in thread: Mark Bannister: "Re: TPE Question"
Reply: Mark Bannister: "Re: TPE Question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Fellow RP-ers:

This is barely on-topic, but I was wondering if any of you had any
experience or knew any leads
on injection-molded TPEs. Specifically, I was wondering what paint or
ink systems could be
used on TPE's that were reasonably durable and flexible. Any help would
be appreciated.
Thanks!

Brad Wright
Wright Engineering and Applied Technologies
WrightEngr@gomontana.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Deak, Steve: "SLA500 Solid State Upgrade"
Previous message: liu@ncatmail.ncat.edu: "SME Region 2 Career Fair"
Next in thread: Mark Bannister: "Re: TPE Question"
Reply: Mark Bannister: "Re: TPE Question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:33 EEST