.stl format

From: Evan Smyth (ereiam@earthlink.net)
Date: Tue Feb 10 1998 - 20:11:12 EET

Next message: bvanhiel@nordson.com: "re: VIRUS NOTICE!!!!"
Previous message: Miller, Michael W: "Sibco LOM material"
Next in thread: Anthony Martin: "Re: .stl format"
Reply: Anthony Martin: "Re: .stl format"
Maybe reply: Alexandre L. PAPADATOS: "Re: .stl format"
Maybe reply: Alexandre L. PAPADATOS: "Re: .stl format"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I'm working on a piece of software to accompany my Ph.D. and I am
interested in adding in a "export stl" feature. I've tried searching the
web but I have been unable to find any documentation on this format. Is
there a spec somewhere that I can take a look at?

Thanks in advance!

Evan

-- 
NOTE: Depending on the state of my email program when I sent this, you
may not be able to "reply" to this email without removing "NOSPAM"
from the address. The same goes for the addresses below. (If there is
no "NOSPAM" in the return address, then all is fine!)
***\ Evan Smyth     ereiam@NOSPAMearthlink.net
***/ Los Angeles    California
**/ Alt. Email: esmyth@NOSPAMmit.edu, ereiam@NOSPAMix.netcom.com
*/ /***************************************************************
/ /****************************************************************
Tip the world over on its side and everything loose will land in 
Los Angeles.
- Frank Lloyd Wright
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: bvanhiel@nordson.com: "re: VIRUS NOTICE!!!!"
Previous message: Miller, Michael W: "Sibco LOM material"
Next in thread: Anthony Martin: "Re: .stl format"
Reply: Anthony Martin: "Re: .stl format"
Maybe reply: Alexandre L. PAPADATOS: "Re: .stl format"
Maybe reply: Alexandre L. PAPADATOS: "Re: .stl format"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:53 EEST