Surface Finish

From: gautham@asu.edu
Date: Fri Nov 21 1997 - 23:02:37 EET

Next message: Bruce Okkema: "FW: Tooling Resins vs. SLA"
Previous message: jim@paramountind.com: "Re[2]: Tooling Resins vs. SLA"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

hi,
I am a grad student at the Arizona State University. I am
currently working on characterizing the surface finish on rapid
prototyped parts from the GEnisys m/c( from Stratasys).
I would like to know if any of you know of a surface roughness measuring
device which can be used for the rough surfaces produced by rp m/cs.
I am talking of RMS values in the range of 200-1000.

Thanks,
Gautham Kattethota

Next message: Bruce Okkema: "FW: Tooling Resins vs. SLA"
Previous message: jim@paramountind.com: "Re[2]: Tooling Resins vs. SLA"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:47 EEST