Lost Foam Casting Facilities?

From: Tim Gornet (tjgorn01@starbase.spd.louisville.edu)
Date: Thu May 15 1997 - 17:33:29 EEST

Next message: PLYMROCK@aol.com: "RP maintenance"
Previous message: Elaine Persall: "Re: Job Opportunity in Malaysia"
Next in thread: Michael C Maguire: "Re: Lost Foam Casting Facilities?"
Maybe reply: Michael C Maguire: "Re: Lost Foam Casting Facilities?"
Reply: michael rees: "Re: Lost Foam Casting Facilities?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I am trying to track down a prototype lost foam casting house. I have
checked out the Thomas Register, but all have been high volume folks
and not the 1-5 part range people. Maximum Part size is fairly large
about 3-4 ft square with .25 in. wall. Anybody know of any prototype
facilities that can handle this type of part size and quantity?

Tim

-- 
Tim Gornet		   	Computer Aided Engineering Consultant
INTERNET:  tjgorn01@starbase.spd.louisville.edu
SLUGNET:   Vogt Bldg. Rm 101, University of Louisville, Louisville, KY
40292
PHONENET:  (502)852-0714 	FAXNET: (502)852-8890

Next message: PLYMROCK@aol.com: "RP maintenance"
Previous message: Elaine Persall: "Re: Job Opportunity in Malaysia"
Next in thread: Michael C Maguire: "Re: Lost Foam Casting Facilities?"
Maybe reply: Michael C Maguire: "Re: Lost Foam Casting Facilities?"
Reply: michael rees: "Re: Lost Foam Casting Facilities?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:35 EEST