> Terry Wohlers
> Anyone out there experienced with compression molding of vulcanizing rubber?
Have you talked to Seibolt Hettinga, of Hettinga low pressure
injection molding fame? Interesting man. I've seen some *interesting*
injection molded and comolded rubber parts from his shop. (If you'll
pardon my answering a question different from the one you asked.)
Hettinga Equipment Company
2123 NW 111 Str
Des Moines, Iowa 50322
515 270 6900
Good luck,
Paul
___________________________________________________________________________
Paul Fussell (412) 337 2721 (voice)
fussell_ps@atc.alcoa.com (412) 337 5944 (facsimile)
Alcoa Technical Center, 100 Technical Dr., Alcoa Center, PA, 15069 USA
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:22 EEST