Re: SLS 350

From: David Leigh (harvest@vvm.com)
Date: Wed May 29 1996 - 11:53:12 EEST

Next message: Paul Fussell: "Re: Compression molding of rubber"
Previous message: Terry Wohlers: "Compression molding of rubber"
Maybe in reply to: Pierre Bertrand: "SLS 350"
Next in thread: Pierre Bertrand: "Re: SLS 350"
Reply: Pierre Bertrand: "Re: SLS 350"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

> Is anyone using the new SLS 350? Is there any feedback on the
> tolerances obtained?

I believe you mean SLA 350. DTM does not have a new machine, as far
as I know.
----------------------------------------------------------
David K. Leigh voice (817) 742-1822
Harvest Technologies fax (817) 742-0053
Rapid Prototyping Center e-mail harvest@vvm.com
----------------------------------------------------------

Next message: Paul Fussell: "Re: Compression molding of rubber"
Previous message: Terry Wohlers: "Compression molding of rubber"
Maybe in reply to: Pierre Bertrand: "SLS 350"
Next in thread: Pierre Bertrand: "Re: SLS 350"
Reply: Pierre Bertrand: "Re: SLS 350"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:22 EEST