Re: [rp-ml] Low Cost RP and easy to use RP Equipment?

From: The Creature Company <>
Date: Sat Jan 01 2011 - 17:41:11 EET

HAve you looked into the solido 3d?

On Sat, 01 Jan 2011 02:07:13 -0800, Chuck Stapleton <>

> Hi everyone,
> Happy New Year!
> I'm looking for a low cost and easy to use RP machine for my personal use
> and very limited commercial use. Not looking to spend a lot of time with
> cleaning parts and want as close to "plug and play" as possible.
> Looking at the VFlash and the uPrint, but can anyone offer some other
> suggestions? I know some cool stuff must have come out of Euromold.
> Not So Rigid Requirements:
> * $15k Budget
> * Don't care about colors
> * Easy postprocessing
> * Cheap Material
> * Good accuracy (100 microns)
> * Small build area is ok
> * Slow build time is ok
> Objet Alaris is out of my budget range, but seemed like a great choice.
> Thanks for the help!
> -Chuck Stapleton

Lino P. Stavole
The Creature Company
cell: 661.433.5283
This e-mail transmission, including any previous messages or attachments  
to it, is covered by the Electronic Communications Act, 18 U.S.C  
2210-2521, is confidential and may be legally privileged. This E-mail  
contains information that is private, confidential, or is protected by  
confidentiality or non-disclosure product doctrines, and is intended only  
for the use of the individuals(s) names herein. If you are not the  
intended recipient, be advised that unauthorized use, disclosure, copying,  
distribution, or the taking of any action in reliance on this information  
is strictly prohibited. If you have received this E-mail in error, please  
immediately notify the sender by replying to this E-mail, and delete the  
original message any attachments
Received on Sat Jan 01 17:31:44 2011

This archive was generated by hypermail 2.1.8 : Sat Jan 07 2012 - 13:25:43 EET