Re: [rp-ml] problem with Zprinter

From: The Creature Company <>
Date: Thu Dec 23 2010 - 01:43:04 EET

It's been my experience that zcentral and zcorp technical service reps are
very helpful and informative about all errors. Did you try them? They even
offered me advice with my one test legacy machine.


On Wed, 22 Dec 2010 09:18:21 -0800, Yaser Shanjani <>

> Hello,
> Our ZPrinter 310plus does not work properly and keep giving the
> following message when we connect a monitor to the main PC board on the
> machine:
> "Fatal Error KERNEL. 146040: No waithost specified but no application
> presentSetting run mode to -waithostReady for debugger commands"
> I was wondering if anyone can advise us how to deal with this problem.
> Where can we find the debugger commands?
> Thanks,
> --Yaser Shanjani

Lino P. Stavole
The Creature Company
cell: 661.433.5283
This e-mail transmission, including any previous messages or attachments  
to it, is covered by the Electronic Communications Act, 18 U.S.C  
2210-2521, is confidential and may be legally privileged. This E-mail  
contains information that is private, confidential, or is protected by  
confidentiality or non-disclosure product doctrines, and is intended only  
for the use of the individuals(s) names herein. If you are not the  
intended recipient, be advised that unauthorized use, disclosure, copying,  
distribution, or the taking of any action in reliance on this information  
is strictly prohibited. If you have received this E-mail in error, please  
immediately notify the sender by replying to this E-mail, and delete the  
original message any attachments
Received on Thu Dec 23 01:35:01 2010

This archive was generated by hypermail 2.1.8 : Fri Mar 11 2011 - 05:24:19 EET