RE: [rp-ml] Solid Freeform Fabrication Conference

From: Taylor, Tracy L PWR (
Date: Mon Sep 10 2007 - 19:28:23 EEST

Interesting....But I was under the impression that 3D Systems main goal
was to make the system more turnkey, improve the speed, and improve the
surface finish on the parts. It sounds like they accomplished their
primary goals. If you need a production system that will produce the
best mechanical properties maybe you should make that your primary goal.
Personally most of my experience is using nylon 11 and it's true that
the stock 3D algorithms are not optimized for mechanical properties.
With a bit of work they are quite capable machines in my opinion. With a
bit of tweaking I saw no difference between the Hi-Q and base Vanguard
HS machines running nylon 11. That's about all I can say without getting
myself in trouble.
Just curious if you had ever compared your EOS machines (Do you still
work for EOS?) to 3D Systems offerings with mechanical properties being
the goal.
Thanks for the post. When I have time I will check out the paper.
Tracy Taylor
Strategic Fabrication Center
Pratt & Whitney Rocketdyne, Inc.


From: [] On
Behalf Of Shane Collins
Sent: Friday, September 07, 2007 7:51 PM
Subject: [rp-ml] Solid Freeform Fabrication Conference

Those who did not attend the Solid Freeform Fabrication Conference in
Austin, TX last month may have missed this paper. Clearly, there is a
big difference between prototyping and direct manufacturing.



8:50-9:15 Comparison of Material Properties and Microstructure of

Specimens Built Using the 3D Systems Vanguard HS and Vanguard

HiQ+HS SLS Systems

T.J. Silverman, A. Hall, B. South, W. Yong, J.H. Koo, University of

The HiQ upgrade to the 3D Systems Vanguard selective laser sintering

machine incorporates a revised thermal calibration system and new

software. The paper comparesthe tensile modulus, tensile strength,

at break, flexural modulus, Izod impact resistanceand microstructure of

batteries of standard specimens built from recycled Duraform PA (Nylon

The first set is built on a Vanguard HS (High Speed) system and the
second on

the same system with the HiQ upgrade installed. A third set of specimens
is built

using fresh material to establish an independent baseline for the

properties of HiQ-processed Duraform PA. The upgrade reduces user

intervention, decreases total build time and improves surface finish.

tensile, flexure and impact properties are all found to decline after
the upgrade is




This archive was generated by hypermail 2.1.7 : Tue Jan 01 2008 - 18:13:07 EET