From: Gary D. Mitchell (Gary@acucast.com)
Date: Wed Dec 20 2006 - 16:35:07 EET
3D Systems introduced it yesterday at the open house. Under $10,000 calling it FLASH. 3D Systems has setup a separate web site but I can't remember the address something flash. No parts were shown just the machine. Looked compact about the size of a high-end paper printer.
3D Systems has built a very impressive operation in Rock Hill.
Gary D. Mitchell
Acu-Cast Technologies, LLC
Phone: 931 762 6004
Mobile: 931 212 0167
----- Original Message -----
To: firstname.lastname@example.org ; email@example.com
Sent: Thursday, January 18, 2007 7:28 PM
Subject: [Spam][3.58] Re: [rp-ml] New Low Cost 3D Systems 3D Printer
In a message dated 1/18/2007 7:09:14 P.M. Eastern Standard Time, firstname.lastname@example.org writes:
Check out http://biz.yahoo.com/bw/070118/20070118005211.html?.v=1
Anyone know the specifics?
B. Matthew Michaelis, Ph.D.
Physical Optics Corporation
20600 Gramercy Pl. Suite 100
Torrance, CA 90501
Phone: 310.320.3088 x154
See the top of this page:
Here's the straight poop on it from this quarter's Additive Fabrication Spy (TM) Newsletter:
* "3D Systems has had a couple of patent applications published this period for what might be next-generation photopolymer-based technology. One describes the use of an endless transparent belt to provide thin, bubble-free layers of photopolymer at the top of a build stack. Area-wise exposure is done through the belt using a spatial light modulator such as a deformable mirror device (DMD). A second patent application presents methods of increasing the resolution and edge smoothness parts fabricated with such exposure devices. In addition, specific photopolymer materials with characteristics which fit the process are being explored by the company."
Castle Island Co.
781-646-6280 (voice or fax)
The Worldwide Guide to Rapid Prototyping
* Copyright Castle Island Co., All rights reserved
This archive was generated by hypermail 2.1.7 : Tue Jan 01 2008 - 18:13:00 EET