Re: [rp-ml] Humidity control in Z-Corp. 3D Printer

Date: Mon Feb 13 2006 - 12:31:04 EET

Dear Dr Adel,

In 3D Print Setup, you can adjust only the saturation level, the other
parameters are linked.

The anisotropic factor is for correcting the dimension changes in X, Y, Z
axis after post-treatment.

The quantity of binder going through the printhead jets is about 0,032 ml
per million pixel. It's an average quantity calculated with standart
saturation level.

For the clogged head : try to force jets with binder in the resevoir and a
seringe of air on the reservoir, or use an ultrasonic cleaner.

Best regards.

Philippe Guérin
Technico commercial Zcorp
Z.I. du Chapotin
69970 Chaponnay
Tél. : 04 78 96 80 00
Fax : 04 78 96 80 01
e-mail :
Received on Mon Feb 13 10:25:27 2006

This archive was generated by hypermail 2.1.8 : Tue Jul 21 2009 - 10:27:51 EEST