RE: Lost Core Urethane Castings

From: Bart Mol (bart.mol@somatech.nl)
Date: Mon Aug 25 2003 - 11:16:36 EEST


Yes you can if you have ¤nsight software. With this software you can change the generated extrusion paths from model to (soluble) support material. This is not possible with Catalyst software (Dimension 3D Printer).

__________________________________________________________
Greetings,

Bart

 -----Oorspronkelijk bericht-----
Van: fanbelt.1@netzero.com [mailto:fanbelt.1@netzero.com]
Verzonden: zondag 24 augustus 2003 6:54
Aan: rp-ml@rapid.lpt.fi
Onderwerp: Lost Core Urethane Castings

We are planning to make some flexible hollow urethane castings. The interior volume of these parts will have significant undercuts in the direction of draw, so a conventional permanent core for the molds won't do the job.

Does anyone have any advice regarding possible core materials that can witstand the moderate heat generated when urethane resin cures, yet can be melted or dissolved out of the finished part?

We've thought about using the wax material that can be used in a stratasys FDM system, but were concerned about the heat generated during curing of the part. Also, we'd considered using the water-soluble Styratasys support material, but we're not sure if we can "trick" the system into creating a part that consists only of the support.

Any advice or ideas?

Thanks in advance

John

________________________________________________________________
The best thing to hit the internet in years - NetZero HiSpeed!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month -visit www.netzero.com to sign up today!



This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:56 EET