From: Scott Tilton (firstname.lastname@example.org)
Date: Fri May 16 2003 - 18:14:09 EEST
You are assuming he has a late enough version of the software to do such
things as change the build mode or turn on Auto Feed.
Not everyone is so fortunate. ;-)
I'm a little swamped at the moment to look up the settings that are switched
to when I change build modes, but if no one does answer with some
temperature, feed height, laser power settings. . . ask me again next week
and I'll see if I can't help.
From: Timothy J Gornet [mailto:email@example.com]
Sent: Friday, May 16, 2003 10:25 AM
To: firstname.lastname@example.org; email@example.com
Subject: Re: Increasing the layer thickness in SLS?
The easiest way to do that is under the Tools, Change Build Mode in the
build setup software.
It then automagically takes care of the settings. Make sure to use Auto
Feed as well so that you don't short feed the powder.
Tim Gornet Computer Aided Engineering Consultant
SLUGNET: Vogt Bldg. Rm 101, University of Louisville, Louisville, KY
PHONENET: (502)852-0714 FAXNET: (502)852-8890
Rapid Prototyping Center
>>> Stefan Donovski <firstname.lastname@example.org> 05/13/03 04:04AM
I'm interested in influence on the layer thickness in SLS process.
I'm using DTM's Synterstation 2500 plus system.
I usually work with 0,10mm layer thickness, but I have heard that I
decrease my build time if I increase this value to for example 0.12mm.
Should I increase the laser power too, and is there any math
between these two variables. Which is the biggest value if it is
I haven't done this, but when I set this value just in the software
following message appears on my screen:"DTM suggested 0.1mm ..97%"
I will deeply appreciate Your help.
SPARKY GmbH, Sofia
tel: (+359 2) 93-20-559
fax: (+359 2) 93-20-510
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:32 EET