From: Paul Suomala (email@example.com)
Date: Wed Apr 23 2003 - 14:37:21 EEST
You can use cyanoacrylate, wax weld or (my favorite)
* Cyanoacrylate sets very quickly - ok for pieces that
are broken, having jagged edges which act as alignment
features. But if you miss, you are in trouble.
* Wax welding (the seam) is ok if you can clean the weld
line before or after casting. The green material melts
at 95 deg C. This method will give you the cleanest
burnout if you are investment casting the part(s).
* Fingernail polish is very forgiving due to having a
relatively long set-up time. You need to maintain a
fixtured position for a few minutes - the time is
dependent upon how much of the nail polish you use. It
is forgiving - if you err, you have time to take it
apart and try again.
* As an added note, I have tried rubber cement. Found it
to be difficult to control at gluing time and too
flexible when cured. Not sure how it would affect
If you are not investment casting, but rather making a
rubber mold of the part, epoxy could be an option. Of
course, epoxy is not so easy to control...
Please let us all know what results you have.
> Hello all,
> I have some Solidscape models that are in several pieces.
> Is it possible to glue these together?? Does anyone have
> experience with this?
> Thanks in advance.
> Clayton Wilson
> AIO/PhD Student
> University Medical Center Utrecht
> The Netherlands
> Tel: +31 (0)30 2295135
> Fax: +31 (0)30 2280255
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:23 EET