From: Michael Tsenter (email@example.com)
Date: Mon Jan 27 2003 - 20:45:09 EET
Some of our customers use a primer and then PPG automotive paint. The mold
release that you use on the molds should be a paintable mold release. You can
contact Stoner, Inc. 717-786-7355 to get the right release.
Also, when you make so many parts, a better alternative, if possible, would be
to color match the resin.
Our PC1121/G121 system works well for color matching and produces a tough rigid
part that simulated ABS.
-- CAMATTINI - North America a division of NEST Technologies, Inc. 3849 Ridgemoor Drive Studio City, CA 91604 USA Tel: 818-761-6500 Fax: 818-761-6116 e-mail: firstname.lastname@example.org web site: http://www.nesttechnologies.com Andrew Miller wrote: > I need suggestions on paint for Cast urethane parts > > We have in the past had quite good sucsess with urethane based automotive > paint. But it is quite knoxious in anything but small doses. > > We may have a need to hand paint 500 models. And are in need of paint that > doesn't require $50,000 in ventilation equipment to use. > > We must have a hard finish that bonds well. > > any suggestion are welcome.
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:04 EET