From: Blasch, Larry (LBlasch@OPW-FC.com)
Date: Mon Jan 27 2003 - 20:00:17 EET
At 08:48 PM 1/23/2003 -0500, Rob Connelly wrote:
I have a resin question for the group. I have a customer who wants
to make some tiny little parts on a high-res SL machine for a medical
application. Trouble is, he needs the parts for a process similar to
investment casting wherein he will shell them with something, and then
dissolve the SL part back out of the shell. He can't use high temperatures
as in investment casting -- he needs to use a solvent.
So, is anyone aware of a resin that can be used in a high-res SL
machine (either a Viper or a 250HR) that can dissolve in acetone, xylene,
MEK, or other such nasty chemical? Do the old acrylates dissolve? My
customer has told me that just softening or deteriorating is not good enough
-- it has to dissolve. If this does exist, do you know of a vendor who has
this combination to whom I can outsource the job?
Thanks in advance for your time,
FineLine Prototyping, Inc.
6300 Limousine DR
Raleigh, NC 27613
How about trying the zcorp machine with powdered sugar? Or pure corn starch.
I can't think of anything else that would dissolve out well enough to work.
Might be a problem with resolution if the parts are that small.
You might be able to pull a silicone mold off of the SLA part and mold
something soluble into that as an alternative. (Melted sugar perhaps?)
PS: I must have sugar on the brain today.
The above correspondence contains, my opinions, and such. If you disagree
with me, send $100 to the address below and I'll consider your point of
< System Administrator Alert: >
< From: System Administrator >
< Subject: The recipient(s) mailbox is full >
< due to excessive donations >
Lawrence R. Blasch
CAE Systems Administrator
OPW Fueling Components
P.O. Box 405003
Cincinnati, OH 45240-5003 USA
Voice: (513) 870-3356
Fax: (513) 870-3338
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:04 EET