From: Scott Tilton (firstname.lastname@example.org)
Date: Tue Dec 10 2002 - 17:52:38 EET
I've got a question for the SLS users out there.
I had a job for some big ugly parts . .ones that don't have relatively low
requirements for surface finish and part accuracy.
So I loaded up some Duraform powder that is pretty much only good for
building such parts and ran myself off some test parts to try and get some
calibration values on it.
With old powder, that's not the easiest thing in the world to do actually.
I resort to actually making one of the parts in question .. (or at least a
partial cross section of it) and then using that as the basis for further
I also ran the standard beam coupons and scale pyramids for the heck of it.
They come out with some funky sidewalls.
They seem to be concave in any place where there is a significant amount of
cross sectional area being scanned by the laser.
Can anyone help to explain why this happens or any techniques for lessening
Take a beam coupon for instance.
It is essentially a small plate 4" x 1" x .25" (x, y, z directions
With old powder, the top and bottom .025" of the part have a pronounced lip
They are significantly larger than the middle .200" (in the Z direction) of
What causes the extra shrinkage or contraction in the middle?
Or . . . if you like . .why doesn't the bottom and the top of the part
contract as much as the middle?
Curious minds want to know.
Thanks in advance.
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:43 EET