From: Charles Overy (email@example.com)
Date: Tue Dec 03 2002 - 03:29:44 EET
On the less espensive end there are some programs specifically oriented to
milling stl that have all been mentioned on the forum.
http://www.deskproto.com - Deskproto Two versions crom about $300 to aabout
http://www.millwizard.com - a very simple Delcam program that does not
appear to still be under development about $200 I think
As you get into more full featured milling.
http://www.mecsoft.com/ - Visual Mill - free version (fits category above)
and full version
and industry standards like
And many many others listed here http://www3.sympatico.ca/deepak/cadcam.htm
What you chose will depend as much on your mill and your milling
requirements, your skill level with machine tools, and how often you want
to do this.
From: firstname.lastname@example.org [mailto:email@example.com]On Behalf
Sent: Monday, December 02, 2002 4:29 PM
Subject: .stl to nc code
I would like to mill out portion of an .stl file. I believe I remember
some discussion of software that would do that easily. Thanks for the info.
Stephen M Schmitt
Tel Med Technologies
San Antonio TX
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:42 EET