From: PT Mativenga (P.Mativenga@umist.ac.uk)
Date: Thu Oct 24 2002 - 13:10:08 EEST
Well the value you have quoted for the SLS machine seems too
high - 7.5m/sec = 450m/min. That is more than ten times the rapid
traverse speed of a good 40m/min High Speed Machining Centre.
On 24 Oct 02, at 5:18, Venkatesh Gandhi wrote:
Date sent: Thu, 24 Oct 2002 05:18:28 +0100 (BST)
From: Venkatesh Gandhi <firstname.lastname@example.org>
Subject: Speed of the Machine - Reg
> Hi Friends,
> I found the speed of the Fused deposition modeling machine as 26mm/sec and the solidification rate as 0.1 sec
> And also for Selective laser sintering machine - Speed = 7.5 m/sec
> Can any body conform this value.
> Post your ad on Yahoo! India Autos.Check out the used Maruti, Fiat and Ford models on sale now.
Dr P T Mativenga
University of Manchester Institute of Science and Technology
Department of Mechanical, Aerospace and Manufacturing Engineering
Sackville Street, Main Building
P O Box No. 88, Manchester M60 1QD
Tel 0161 200 3821 (overseas) 44 161 200 3821
Fax 0161 200 3803 (overseas) 44 161 200 3803
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:30 EET