From: Tim Goddard (TGoddard@DStarEngineering.com)
Date: Wed Sep 11 2002 - 23:24:01 EEST
Thank you for responding, I have a few more questions for you if you don't
mind. What material was used? Methacrylates? does a web resource exist where
the physical properties are analyzed, or could you in your own words detail
them. I'm curious to know how durable these parts are. Or is methacrylate a
"Knitter, Regina" wrote:
> Recently, we got some parts built on the perfactory in the high resolution
> mode. The parts have a very good quality and a surprisingly high resolution.
> I think, they will present their equipment at the Euromold in Frankfurt.
> Best regards
> Dr. Regina Knitter
> Research Center Karlsruhe
> -----Ursprüngliche Nachricht-----
> Von: Tim Goddard [mailto:TGoddard@DStarEngineering.com]
> Gesendet: Mittwoch, 11. September 2002 15:20
> An: email@example.com
> Betreff: Envision Technologies
> I'm curious to know whether someone has seen or heard anything about the
> perfactory system. I gathered from their website that it would be
> reaching market late in 2002.
> For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:16 EET