Need Urethane Recommendation

From: Bob Olsen (Bob@protogenic.com)
Date: Wed Jul 03 2002 - 23:46:51 EEST


Hi, we have a request to cast a bezel with the RTV mold process. The part
is about 20" x 4" x 1", nominal wall stock is .125" .
 
Material requirements are 94-VO, and a DTUL / HDT around 75C or greater.
Internally, our preference is for a urethane that can be poured at room
temperature (we can post cure at elevated temps), and has a pot life greater
than 4 minutes, and a viscosity of less than 500 .
 
Any suggestions for a suitable urethane and supplier that approach these
specs would be greatly appreciated. Thanks! Bob

Protogenic - Always on time,
                          Always great Customer service,
                              Always top quality.

=======================================
Bob Olsen marketing manager
1490 West 121st Avenue, Suite 101
Westminster, CO 80234-3497

* Direct: 303-453-3990
* Main: 303-252-0212
* Fax: 303-252-0223
* bob@protogenic.com
* web: http://www.protogenic.com <http://www.protogenic.com/>
=======================================

 

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/



This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:00 EET