From: Henry Sommer (firstname.lastname@example.org)
Date: Wed Jul 03 2002 - 02:09:11 EEST
The sculptures are nice and it is an interesting technology. This seems like
a good use for the tools in Imageware and the other reverse engineering
software that will turn a surface into a point cloud. You could take a
surface you modeled else where and sample it. Also you could fit a surface
to an unorganized point cloud and then sample that surface in an organized
manner to make a better looking sculpture.
Can the software for the scanner that created the data manipulate the clouds
to align them?
> -----Original Message-----
> From: email@example.com [mailto:firstname.lastname@example.org]On
> Behalf Of Bathsheba Grossman
> Sent: Tuesday, July 02, 2002 2:56 PM
> To: email@example.com
> Subject: RE: Novice 3d scan question: stitching point clouds
> It seems like all the software that does this is very expensive and
> also does a lot of other things not relevant to this application. So
> we'll probably end up either getting it done as a service, or with me
> writing a wee tool to do the job.
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:59 EET