From: Dick Edwards (email@example.com)
Date: Mon Apr 08 2002 - 21:28:43 EEST
It can be done with either process, however, for the laser process, the
relatively close proximity of the holes will require some careful
programming to counteract the accumulation of heat.
Abrasive WaterJet (AWJ) would be my choice because there is no heat
involved with the process.
If you don't have a local waterjet house I can recommend:
2910 W. RT 30
Rock Falls, IL 61071
Ask for Jason Near.
706 E. River Drive
Davenport, IA 52803
phone: 563-884-8180 ext. 118
toll free: 800-357-6272
>From: AHASTBACKA@prodigy.net [mailto:AHASTBACKA@prodigy.net]
>Sent: Monday, April 08, 2002 1:18 PM
>Subject: Machining of Alumina Plate
>I need to make 25 square holes of 0.4 inch size with
>0.8 inch spacing in a 6 inch by 6 inch by 1/4 inch
>thick alumina plate. Does anyone on the list have any
>experience in machining something similar to this
>using a laser or water jet process?
>For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:40 EET