From: Jim Williams (JIM@paramountind.com)
Date: Fri Apr 05 2002 - 02:17:22 EEST
Our 2500 plus has been acting up recently. It seems without rhyme or reason,
sporadically the build cakes will come out very hard. Hard enough most
often causing us to trash the build entirely. We can be running the same
batch/lot of material. The problem does not discriminate based on material
type. It's happened with PA, PA/GF and CastForm. The problem does not
appear to be Z height dependent either. All machine parameters are set
based on statically processing.
The problem first occurred after we got jolted during a storm. That was
roughly 3 months ago. It fried a fuse in the sinterstation and the piston
heater. DTM advised us to disconnect the piston heater since with newer
machines it's been omitted. They also sent us a patch for the software.
The machined recovered, or so it seemed. As I said it's sporadic. We
haven't had the problem for 2 weeks. Any ideas would be welcomed.
Jim Williams, President and CEO
Paramount Industries, Inc.
2475 Big Oak Road
Langhorne, PA 19047 USA
(215) 757-9611 x229
(215) 757-9784 fax
(215) 620-0363 mobile
(610) 847-9611 home-office
(610) 847-1279 home-fax
Design... <http://www.definitive-design.com/> www.definitive-design.com
Develop... <http://www.paramountind.com/> www.paramountind.com
Deliver... <http://www.ttm-usasia-mfg.com/> www.ttm-usasia-mfg.com
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:40 EET