Re: Stripping resins off SLA parts

From: Bob York (byork@metroplastics.com)
Date: Thu Mar 07 2002 - 17:31:29 EET


This is interesting...
Any Vantico, Somos, or RPC folks like to chime in on this?
I am most interested in Vantico 5195, 5170 and 7540.
Also Somos 9120.

Thanks,
Bob York
SLA Technician
Metro Rapid Prototyping
9175 E. 146th Street
Noblesville, Indiana 46061
ph: 317/776.6904 ex.239
fax: 317/776.6913
http://www.MetroRP.com

At 02:16 PM 03/06/2002, Zubrickie, Robert F wrote:
>For those of you who are using TPM to clean off you stereolithography parts
>I came across a product that works as good as TPM and has some cost savings.
>It's Poly-Flush by Dynaloy, Inc. This is a versatile polymer flushing
>solvent. TPM was costing me $125.00 per a 5 gallon container. I am
>purchasing the Ploy-Flush from The Smith Group, Inc. for the cost of $85.00
>per a 5-gallon container. I have been testing this with the following resins
>DSM 8110, RPC100HC, RPC600HC, and RPC692HC. I put my platforms with the
>parts attached in an aeration tank of Poly-Flush for approximately 15 to 25
>minutes; let drip dry then dunk the platform in denatured alcohol to remove
>the Ploy-Flush. I have built thin walls and small deep cavities; so far I
>found no signs of warp-age or softening of the SLA parts. I even
>accidentally forgot about the SLA parts in the Poly-Flush for 1- hours with
>no harmful effects. I noticed that, as TPM gets old and saturated with
>resins; it does not work as effective. I find that the Ploy-Flush continues
>to work well stripping off the SLA resin even when it becomes saturated with
>resin. The SLA parts are not sticky with saturated Poly-Flush like as TPM.
>Anyone interested in this product can contact Darin Cesan at The Smith
>Group, Inc. Phone # (215) 957-7800 (800) 345-7524 Fax # (215) 957-9600 or
>e-mail at decesan@thesmithgroup.com
>
>I am not endorsing this product, nor am I trying to sell this product. I'm
>merely sharing my findings. Maybe someone out there can benefit from this.
>
> TYCO / ELECTRONICS
> Global Communications, Computer & Consumer
>Electronics Business Unit
> _______________________________________________
> | Robert F. Zubrickie
> |Manufacturing Engineer
> |Rapid Prototyping Area
> |3101 Fulling Mill Road, MS 128-98
> | Middletown, Pa 17057-3164
> |
> | E-Mail: bob@tycoelectronics.com
> | Phone - (717) 592-5208
> | Fax - (717) 592-4943
> |____________________
>
>
>
>For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/



This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:32 EET