In a message dated 01-08-22 12:13:11 EDT, you write:
<< I'm sorry to bring up this perennial chestnut again but does anyone know if
an IMPARTIAL rapid tooling matrix has yet been created. It seems that the
factors that determine preference for 1 system over another are so many and
varied that I am finding that I am repeatedly having to obtain quotes from a
selection of suppliers (and this despite the fact that I studied RP and RT
applications at Warwick University and am therefore probably more informed
that most other design managers!). Given that in each case only one supplier
can win, I'm conscious that others are going to start to feel that they are
being used as a stalking horse and may become less inclined to quote. An RT
matrix has the potential to make design managers more informed and therefore
cost RT bureaux less in quotes for lost causes.
I'm looking forward to your replies
Senior Development Manager
87 Richford Street
London W6 7HJ
There will be a fairly large set of tooling tables introduced on our site in
the next few days.
I've collected the information over several months from literature and
corporate sources and am finally finding the time to publish it.
Unfortunately, because of the nascent nature of many technologies, and the
fact that some systems makers do a good job of withholding and obscuring
specs, there are some large gaps. However I do think this will be the most
complete set of tables available and will form a framework that can be filled
as time goes on.
Should be available Monday or Tuesday. Our URL is:
Worldwide Guide to Rapid Prototyping
Look for the "Rapid Tooling Survey," - it's part of that section.
Castle Island Co.
19 Pondview Road
Arlington, MA 02474 USA
781-646-6280 (voice or fax)
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:40 EET