I am not sure what your question means, but we infiltrate the parts with
epoxy if they are to be used as ceramic/epoxy parts, but we don't infiltrate
them with the epoxy if they will be used as cores for metal casting.
I hope that clear it up.
Dr. Brent Stucker, Director & Asst. Professor
Rapid Manufacturing Center
University of Rhode Island
Dept. of Industrial and Manufacturing Engineering
Gilbreth Hall, 2 East Alumni Ave.
Kingston, RI 02881
ftp: rmc1.ime.uri.edu (anonymous login)
From: email@example.com [mailto:firstname.lastname@example.org]On Behalf Of
Sent: Monday, April 23, 2001 10:12 PM
Cc: JP Harrison; RPML2
Subject: RE: RP ceramic cores
I have a question. You wrote,
>We can infiltrate it with a high-temperature epoxy if needed.
It means that the melt is low temp.melting point materal
because of burn out during pouring the melt ?
"Brent Stucker" <email@example.com> 2001/04/23 22:24:09
$B08@h(B $B!'(B "JP Harrison" <firstname.lastname@example.org>, "RPML2"
cc $B!'(B $B!J(Bbcc$B!':#B<(B $B@5?M!K(B
$B7oL>(B $B!'(B RE: RP ceramic cores
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:08 EET