On Mon, 9 Apr 2001, Paul L. wrote:
> What RP technology is best for use as an investment casting master ?
For small parts, Solidscape.
Big parts, it depends. If the part only needs to have one side with
good detail, Thermojet is probably a cheap good answer. If there are
a lot of undercuts, cost is a factor and you don't mind a rough
surface, ZCorp may do. Then if you have more money there's DTM, SLA
and so on: all have their good and bad points.
What's it for?
Bathsheba Grossman (831) 429-8224
Creative prototyping www.protoshape.com
Bronze sculpture bathsheba.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:04 EET