There's not much you can do, you may:
1. Divide your model into smaller, easier to access pieces and,
2. Re-orientate your model to eliminate supports and,
3. Use fine-point support.
You may also take a look at the current splash screen of our Rapid Product
Development Resource Centre web site ( http://rpdrc.ic.polyu.edu.hk ), which
show a typical result of the above three steps.
WAI Hon Wah
Senior Project Fellow
The Hong Kong Polytechnic University
T: +852 2766 4293 F: +852 2334 4634
> -----Original Message-----
> From: firstname.lastname@example.org
> [mailto:email@example.com]On Behalf Of
> Lew Kok Fah
> Sent: Thursday, 8 March, 2001 9:34
> To: 'firstname.lastname@example.org'
> Subject: SLA architectural model
> Is there any one who has experience in building architectural
> model using
> We have just upgraded our resin to SL5220 recently, and we
> are using 3D
> lightyear to place our part.
> The dimension of the model is about 220x220x190, the problem
> we face is how
> to remove the support in the model? or is it safe to delete
> some of the
> supports away?
> Appreciate your feedback.
> Kok Fah Lew
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:57 EET