We are faced with a problem on a time bound project. Can you please help.
We are doing Spray Metal Tooling of a complex component (like a gear)
The problem is that the SLA pattern sticks to the mould surface and is very
difficult to remove, in the event damaging the mould surface.
Any suggestions to overcome this problem would be greatly appreciated.
Thanks and regards
Please email us at
Fax: 1 810 454 0211
For more info please visit
Updated on July 22, 2000. Please send in your comments.
You can also email us directly for your questions.
INDUSTRIAL DESIGN - MECHANICAL PRODUCT DESIGN - RAPID PROTOTYPING AND
TOOLING - MOLD MAKING AND MOLDING.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:04:21 EEST