We have about the same results with our machine. Most high detail high
precision builds we must build alone in the center of the table. The closer
you get to the edges the accuracy falls off a little.
In a message dated 8/10/00 6:35:32 PM Central Daylight Time,
<< For typical sla's you can get around .001 inch per inch overall accuracy
with a little work. However, feature size is limited to the spot diameter in
XY (about .010-.015 inch) and layer thickness in Z. Small spot lasers must
do better but I don't have any data on them. Hope that helps.
Disclaimer: Engineer and out the other!
I've already told you more than I know.
Michael W Miller (firstname.lastname@example.org)
The Boeing Company M/C 17-PE B-2T65
Propulsion Experimental Hardware 206-655-3289
Rapid Prototyping 655-4366 Lab 655-4365
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:04:04 EEST