Thanks for your response. I think I will have to contact EOS about this one.
From: Liu, Xing Yang <XingYang.Liu@nrc.ca>
To: 'Nigel Warden' <Nigel.Warden@nationwideisp.net>
Date: 17 May 2000 4:23 PM
Subject: RE: impact strength unit conversion
>The Charpy test results were obtained by dividing the absorbed energy with
>the cross section area of the notched section. Therefore you got the unit
>of J/m2. The Izod test gives you the impact resistance that is measured
>dividing the absorbed energy with the specimen width, resulting in the unit
>of J/m. To compare the Izod results with that of Charpy's, you need to
>only the depth of the Izod impact specimen at the notch section which is
>normally 10.2 mm according to the Standard. Therefore, If you divide the
>Izod results with .0102m, then you should have a comparable figure with
>However, when you use this method to convert the results given in your
>message, you get roughly 21 kJ/m2 for the DTM materials, which is roughly
>order of magnitude difference. I do not know why. Maybe the DTM material
>is 10 times stronger than that of EOS'. Hope this helps.
>Mark X. Liu, Ph.D.
>Integrated Manufacturing Technologies Institute
>National Research Council of Canada
>800 Collip Circle, London, Ontario
>Canada N6G 4X8
>Phone: (519) 430-7042
>Fax: (519) 430-7064
>Email: Xingyang.Liu@nrc.ca <mailto:Xingyang.Liu@nrc.ca>
> -----Original Message-----
> From: Nigel Warden [mailto:Nigel.Warden@nationwideisp.net]
> Sent: Wednesday, May 17, 2000 9:32 AM
> To: email@example.com
> Cc: firstname.lastname@example.org
> Subject: impact strength unit conversion
> Dr Igor Shishkovsky,
> Thankyou for replying to my question. I am not quite sure
>what your reply is
> telling me though.
> I have an example of what I am trying to achieve.
> American standard ASTM D256:-
> Impact strength test (Notched Izod) on laser sintered
> supplied by DTM corp. provides a result of 214 J/m.
> European standard DIN 53453:-
> Notched impact strength test (Charpy) on laser sintered
> supplied by EOS (GmbH) provides a result of 3 kJ/m2.
> How can I convert the EOS result into the same units as the
> Which has the greater impact strength?
> Nigel Warden
> For more information about the rp-ml, see
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:30 EEST