David Maxfield wrote:
> Does this mean that when I used a magnifying glass to start wood on fire
> I was using just 2 watts?
Roughly, yes. My own magnifier is about 7.5 cm diameter, or about .0044
m2 in area. Bright direct sunshine at sea level is about 930 w/m2.
Allowing 10% for absorption and refelection losses at the glass, mine
should be about 3.7 watts.
> > Suppose we pick a 100 watt power rating, that scales us up to a spot of
> > 2.5mm diameter. That sounds awful as a resolution if we are raster
> > scanning, but it is not so awful as a minimum wall thickness if we are
> > smoothly tracing the contours of a cross-section.
> Are we going to be able to fuse more than thermoplastics, without going to
> a vacuum?
Concentrated sunlight can melt anything. (Historically the first melting
of platinum was accomplished in a solar furnace.) The problem is that it
cannot melt things as fast as a laser can. In that brief time heat
diffuses below and to the sides, degrading the resolution in a
selectively sintered part. I don't think going to a vacuum would be much
help in this regard.
Heliakon Solar Sintering Lab
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:02:46 EEST