In a message dated 00-01-21 05:05:28 EST, email@example.com writes:
<< Dear Sirs,
I would like to know if anyone has some reference about the application of
Rapid Tooling technologies in obtaining thermoforming/vacuumforming molds
for manufacturing very thin wall parts.
And Rapid Prototyping aplied to small thickness pieces ( 0.5/0.8/1 mm)?
Not much has been written on this, but here are 3 refs you might find useful.
I'm including the Abstracts with the copy I'm sending you.
Castle Island Co.
19 Pondview Road
Arlington, MA 02474 USA
781-646-6280 (voice or fax)
Authors Kleespies, H. S., III. Crawford, R. H.
Title Vacuum forming of compound curved surfaces with a variable geometry
Source Journal of Manufacturing Systems. v. 17 no5, 1998, p. 325-37.
Title Utilizing stereolithography to produce a rapid prototype thermoforming
Author Cummings, Douglas S. Institution Penn State Erie, Erie, PA, USA
Source Annual Technical Conference - ANTEC, Conference Proceedings n. pt 3
1994. Soc of Plastics Engineers, Brookfield, CT, USA. p 3550-3554. Conference
Information Proceedings of the 52nd Annual Technical Conference ANTEC 94.
Part 3 (of 3). San Francisco, CA, USA. 19940501-19940505.
Title Complex prototype assemblies from stereolithography and RTV tooling
Author Odette, Scott. Institution Delco Electronics Corp
Source SAE Technical Paper Series. Publ by SAE, Warrendale, PA, USA. 1992. p
1-6 920744. International Congress and Exposition. Detroit, MI, USA.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:02:40 EEST