Dear SLA Users,
Recently, we built 14”x14”x 1.5” part on our 500 using 7100. The part
was nearly solid. Upon examination immediately after building, we
noticed that the edges of the part curved upwards and measured .030
higher than the center point of the part.
Has anyone experienced this phenomenon? If so, have you pinpointed the
cause and or a solution? Thanks.
Prototech Engineering, Inc.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:02:33 EEST