We have been involved with two projects:
1) A salad dressing bottle for a well-known company. The bottle
was grown in SL5170, and then used to make an RTV mould, in
which we cast clear epoxy plastic. Unfortunately, we had to make
it in 2 halves, to glue it afterwards.
More technical detail can be obtained from MC Moolman, who
managed our centre at that time, and is now manager of the
prototyping facility at Freeplay engineering.
He can be reached at:
2) We did a R.E. project of an ISUZU back-light for Hella. I can
send you some images if needed.
From: "IAN CAMPBELL"
Organization: Man Eng, Univ of Nottingham
Date sent: Wed, 30 Jun 1999 10:19:39 GMT0BST
Subject: Rapid Prototyping of Glass Products
Copies to: "BENJAMIN RAY" <email@example.com>
> Dear Colleagues
> Does anyone know of any applications where RP models have been used
> to mimic (or produce) glass prototypes e.g. car headlamps?
> References to papers, reports, names would be much appreciated.
> Ian Campbell
> Dr R Ian Campbell
> University of Nottingham
> Manufacturing Engineering
> University Park
> Nottingham NG7 2RD
> Tel: +44 115 951 4015
> Fax: +44 115 951 4000
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
Deon de Beer
Department of Mechanical Engineering
Technikon Free State
fax 27 51 507 3199
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:00 EEST