One of our SLA250/50 is having problems with the leveling system.
On starting a build the leveling adjusts but the "counter" stays at -2,
says that "no manual adjustment necessary" even if there is no resin in
This means that the build crashes as it does not know where its level
I suspect the laser diode and or the PCBA, Bi-cell sensor.
This has also made me think how when the level of the resin is either to
(laser completely off the Bi-cell sensor), or to low (laser completely
Bi-cell sensor) the machine knows where the level is??? What measures
Has any one had a problem similar to this or know where I can buy the
above parts from. (I do realize 3DSystems)
Thank you in advance for any suggestions.....
-- Solid Concepts Phone +61 8 94555377 Unit 1, Fax +61 8 94555344 5 Harvard Way Email: email@example.com Canning Vale Internet: www.solid-concepts.com.au Perth, Western Australia
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:09 EEST