Is the "curling" taking place at the edge of the surface or somewhere else.
We have had a similar problem I believe you are experiencing. Our
downfacing surfaces would curl on us (near the edge) but only when we
supported with gussets. Using Vista & unable to extend the gusset length
out toward the edge, we would support that particular surface with the
basic vertical support (just about .020 from the edge). This would
eliminate the curling affect. Hope this helps your problem.
image moved "Chris Sutcliffe" <email@example.com>
to file: 12/22/98 11:24 AM
To: "rpml" <firstname.lastname@example.org>
cc: (bcc: David Oblak/PD/CoulterUS)
Subject: 5220 at high powers
At the University of Liverpool we have an SLA 250 which is running 5220
with a hot laser (38mw at the vat) we are having dificulty producing good
quality downward facing surfaces. The faces seem to be curling downwards
into the vat producing a series of checkered bumps on the undersurface of
Does anyone out there have any experience with this resin at these powers.
Thanks in advance
Dr. Chris. Sutcliffe
Product Innovation and Development Centre
Department of Engineering
3 Brownlow St.
Liverpool L69 3GL
(0151) 794 8022 Direct
(0151) 794 8021 Secretary
01893 209 556 Bleeper
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:50:42 EEST