Thank you for your response. This is true -- the automotive
manufacturers use rotational molding as a rapid prototyping method for
parts that will be blow molded. We just produced a pattern, aluminum
cast mold, then 16 HDPE fuel tanks in under 4 weeks.
Maybe I had better explain who we are and what we are looking for. We
are a manufacturer of aluminum cast and machined rotational molds:
www.boyce.com. We have a number of customers who do not wish to pay the
$15,000 for five parts and are looking for a less expensive solution.
> From: firstname.lastname@example.org[SMTP:email@example.com]
> Sent: Wednesday, April 08, 1998 9:05AM
> To: firstname.lastname@example.org
> Subject: Epoxy Tooling for Rotational Molding
> Why do you want epoxy tooling? If you have a master, then you can
> cast the permanent tooling from aluminum. Then you'll have a tool
> that any
> rotomolder will run rather than a giant insulator that no rotomolder
> want to run through his oven (rotomolders will run your tool next to
> someone elses on the arm, so having similar cycle times is important).
> Tooling for rotomolding is so cheap that there is little point in
> prototyping it. I am currently designing a rotomolded bin that is
> 20"x20"x30" and the projected permanent tooling cost is ~$15k.
> Brian VanHiel
> Mechanical Engineer
> Nordson Corp.
> Duluth, GA
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:16 EEST