I am interested in learning roughly how many cast epoxy parts one can
expect to get out of a machined delrin mold. The epoxy is very low
viscosity (like water, I'm told) and the part geometry is going to be
fairly forgiving (generous draft and no small features, or so I'm told) and
small, roughly half the size of a small beeper. The molds will probably be
heated to accelerate curing.
Any insights would be appreciated.
950 Rengstorff Ave. Ste. C
Mountain View, CA. 94043
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:09 EEST