I am comtemplating a range of products that will use RP techniques to
produce casting patterns. Most of the components would be small or even
very small (biggest would be about 120 x 35 x 70mm, smallest about 10 x 5mm
dia or less)
Could any one point me in the direction of an Idiot's Guide to designing
for RP ?
so that I could avoid some of the pitfalls I havn't thought of yet.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:04 EEST