My approach is
Resolution: Measure the radius at the intersection of two and/or three planes.
Accuracy: Measure enough parts to establish the process capability to print
tolerances, in the x, y, and z directions.
Surface finish: Compare your RP parts at 45 degrees to and parallel to the
build plane with the usual machioning standards, or use instrumentation.
Tom Richards, Metallurgist
At 08:09 PM 2/20/98 -0800, you wrote:
>Has someone finally developed definitions for feature size, dimensional
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:59 EEST