Re: Sibco LOM material

From: Matteo Righini (m.righini@democenter.it)
Date: Wed Feb 11 1998 - 13:00:34 EET


At 09.59 10/02/98 -0800, Miller, Michael W wrote:
>I'm going to try out Sibco's paper on our 2030. I had never heard of
>this alternate material option before yesterday. Any opinions (good and
>bad) or advice on this material would be welcome. Thanks,
>Michael W Miller (Mike.Miller3@PSS.Boeing.com)
>The Boeing Company MS 17-PE B-XT62
>Propulsion Experimental Hardware 206-655-3289
>Rapid Prototyping 655-4366 Lab 655-4365
>
>For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
>
>

Dear Michael

We have a LOM 1015 and we are trying Sibco's paper now.
I think it's more resistant than Helisys paper but it's more difficult to
manage the process building.
Precisely during the process the surface temperature of part must remain in
a particular window to optimize the sticking of different layers (50C-57C
or 122F-135F).
So you must regulate the heater velocity accordingly and check the surface
temperature during the building process.

I think that with LOM 2030 there are more problems but i don't know precisely.

Kind Regards

Eng. Matteo Righini
Rapid Prototyping Service Manager

DemoCenter
Via Virgilio, 55
41100 Modena, Italy
Phone: ++39 59 848810
Fax: ++39 59 848630

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:54 EEST