If there is another method of producing an injection mold tool faster,
by all means, skip the SL/RP tools. For many parts, finishing the
positive geometry (the part) is far easier than finishing the negative
geometry (the tool). And the bonus is you have cast a tool which can be
reproduced fairly easy if broken.
The downside of cast tools is there is additional steps required. I
like direct SL tools as we are looking for fast answers to engineering
issues. We take the tool from the SLA, polish lightly, and injection
mold with less labor and time than the cast method.
Life is full of trade-offs. A method for one is not necessarily the
best in all cases.
Steve Deak e-mail: firstname.lastname@example.org
Manager-Rapid Prototyping voice: (+1) 513-579-3270
Hasbro Toy Group fax: (+1) 513-579-3250
615 Elsinore Place
Cincinnati, Ohio 45202 USA "Our Business is Fun!"
> From: Ingrid Timmel[SMTP:email@example.com]
> Sent: Thursday, November 20, 1997 1:40 PM
> To: firstname.lastname@example.org; email@example.com; firstname.lastname@example.org;
> email@example.com; firstname.lastname@example.org
> Subject: Tooling Resins vs. SLA
> What is the major advantage of making a SLA mold for injection parts
> casting a mold from heat-resistant epoxy ?
> It takes less time to make, clean up the part and cast the mold, than
> it would
> to set up everything for making a mold from SLA.
> Thanks in advance.
> Ingrid Timmel
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:46 EEST