I'm very interested in spraying steels directly onto SLA. Are there any
specific requirements for steel (say, low carbon etc) or release agent
(other than PVA)? I need more detail about the process.
>From: Halford, Ben[SMTP:email@example.com]
>Sent: Wednesday, October 29, 1997 7:32 PM
>Subject: RE: Metal Spray Tooling
>PVA or Taffa Black will be your best bets, but my expectations are that
>Al will peel off the SLA by about 0.15 mm rather then 2 mm. The issues
>CTE and Tm make Al a very nasty substance to work with - oh and check
>H&S regarding extraction and explosions . As an aside we regularly
>steels directly onto SLA up to 1mm thick. Greater thicknesses are
>but again the tendency for the shell to curl is the limiting factor.
>From: Phil Malone
>To: 'RP mail list'
>Subject: Metal Spray Tooling
>Date: 29 October 1997 15:07
>To fellow RPers,
>I am about to run an experiment using Arc Spray where by I will use an
>aluminium spray onto a SLA part to a thickness of approx. 1 to 2 mm
>back this up with zinc spray . The finished article will hopefully be a
>core and cavity for an injection moulded part .
>Anticipated problem: -Release agent , what should I use to split the
>part out of the Sprayed shell ?
>Has any one had experience with this method .
>Looking forward to a response
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:41 EEST