In a message dated 97-10-02 11:04:39 EDT, you write:
<< Would anyone know metallic RP processes other than RapidTool by DTM and
Keltool by 3D?
Simon - Have you looked at spin casting? While it's not a "traditional" RP
technique (based on solid models) it is very quick & can give you limited
production runs - quite accurate w/LOW tooling costs - NOTE - this does
produce parts directly - unlike Keltool or Rapid tool - I don't think it
would work to produce tooling.
Roy Sheppard Jr.
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:32 EEST